XAN DayTAN™ Coated Regular Punches - Inch

Regular punches with XAN DayTAN™ coating are used in mechanical die-and-punch tooling where stable material penetration and repeatable positioning are critical. The coated punch face helps limit abrasive wear during production, supporting consistent punch-through results over extended runs.

• Automotive and appliance sheet-metal stations: Ideal for standard die sets that punch forms, tabs, and trim features using inch-size regular punch geometry. The DayTAN™ surface is suited to improve punching stability as die cavities cycle.
• Industrial component bracket fabrication: When multiple tip styles (H, J, K, L, N, O, R, V, X, Y, Z) are selected to match part geometry, the regular punch format helps ensure predictable fit in common punch holder interfaces.
• General die applications requiring high repeatability: Use when you need repeatable punching results and easier part identification based on standardized DAYTON LAMINA formatting.

These regular punches are manufactured as standardized punch blanks suitable for die-and-punch applications, and they are finished with the DAYTON XAN DayTAN™ coating to enhance wear behavior at the cutting interface.

• Coating function: The DayTAN™ coated surface is engineered to reduce wear and support punching stability under repeated cycles.
• Hardness/heat-treatment state: The provided product data does not specify the underlying steel grade, hardness (HRC), or the heat-treatment condition (e.g., quenched & tempered, nitrided). Therefore, those values must be confirmed for exact wear/toughness trade-off analysis.
• Tip geometry impact: Tip shapes (H, J, K, L, N, O, R, V, X, Y, Z) influence contact area and cutting load distribution, which can affect durability despite similar base materials.

Select dimensions by matching your die cavity/core requirement to the punch geometry code set and shank/interface needs. This series supports D (shank diameter) from 12 to 250 in, so choose the value that matches your punch holder and guided alignment requirements.

• Tip shape: Choose from H, J, K, L, N, O, R, V, X, Y, Z based on the hole/slot profile to be formed.
• Length selection (standard/alternate coded inches): Use Standard [S] point length B & L of 150 ~ 250. For alternate configurations, B & L ranges vary by code set, e.g., [B] 150–400/150–500/150–600 or [C] 175–600 and [D] 200–600, etc. Select the coded length that meets stack height and die clearance needs.
• Cross-section detail checks: Verify P (0.042 ~ 1.625 in), W (0.062 ~ 0.5 in), and R (0.007 in) match the tooling drawing.

Tolerance and fit requirements are not provided in the data; confirm allowable clearances with your punch holder specs before finalizing the selected dimensions.